if my memory serves me correctly (usually it doesn't) you can try installing LILO on the MBR of the drive, and then config it to route to your WIN98 machine. by the way, why is your /boot so big? mine is about 5M -----Original Message----- From: Justin To: suse-linux-e@suse.com Sent: 12/31/99 9:57 AM Subject: [SLE] Lilo config Hello, I was wondering if anyone could give me a little help. I've run into a problem, and can't seem to figure out exactly, what I need to do. Here's my setup: Adaptec 7880(same as 2940UW if I remember correctly) SCSI ID#0 - 9.1gig IBM w/ 1 partition of win98 fat32. SCSI ID#2 - 4.5gig Seagate w/ Partition 1: /boot 100MB Partition 2: / 3700MB Partition 3: /home 500MB Partition 4: Swap 128MB SCSI ID#5 - Plextor 40X SCSI ID#6 - Panasonic CDR 4x8 -------------------------------------------------------------------- IDE Channel 1 Master - 11.5gig Maxtor Channel 1 Slave - 11.5gig Maxtor Channel 2 Master - Creative DVD 5x Channel 2 Slave - 12.7gig Quantum Bigfoot Basically my ibm is used for 98, my seagate is used for linux. My other harddrives are only used for holding information. What I'd like? I'd like to use lilo to be able to boot win98 and linux. I'm lost when I have to think of where to put it. I'd like it to be on a harddrive so I can choose at boottime. I'd rather not use a floppy for linux. I'd really like to see a config for this. I understand the idea, but when ever I try to install lilo, it says "warning 0x83 is not accessable" or something to that idea. thanks, Justin -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/ -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/
participants (1)
-
RYagatich@csn1.com