Hello ML! all bigger file transactions fail with my scsi devices on my suse 7.1 system (kernel 2.4.10). After a while the device stops copying. Then the scsibus gets reseted. A few minutes later the copying starts again for a moment and stopps then - until next reboot. At this point most scripts like halt or shutdown. I already tried cables and checked termination. below youll find syslog, hardwarespecs, serialno. thx! -Syslogd- sirocco kernel: scsi0:0:1:0: Attempting to queue an ABORT message sirocco kernel: scsi0:0:1:0: Device is active, asserting ATN sirocco kernel: Recovery code sleeping sirocco kernel: Recovery code awake sirocco kernel: Timer Expired sirocco kernel: aic7xxx_abort returns 8195 sirocco kernel: scsi0:0:1:0: Attempting to queue an ABORT message sirocco kernel: scsi0:0:1:0: Cmd aborted from QINFIFO sirocco kernel: scsi0:0:1:0: Cmd aborted from QINFIFO sirocco kernel: aic7xxx_abort returns 8194 [..repeated 6 mal..] sirocco kernel: scsi0:0:1:0: Cmd aborted from QINFIFO sirocco kernel: aic7xxx_abort returns 8194 sirocco kernel: scsi0:0:1:0: Attempting to queue a TARGET RESET message sirocco kernel: aic7xxx_dev_reset returns 8195 sirocco kernel: Recovery SCB completes - relevante hardware: - Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.1 <Adaptec 2940 SCSI adapter> aic7870: Single Channel A, SCSI Id=7, 16/255 SCBs IBM Model: DPES-31080 Rev: S31Q Type: Direct-Access ANSI SCSI revision: 02 IBM Model: DPES-31080 Rev: S31Q Type: Direct-Access ANSI SCSI revision: 02 QUANTUM Model: FIREBALL_TM2110S Rev: 300X Type: Direct-Access ANSI SCSI revision: 02 [+ 2 CDrom laufwerke] scsi0:0:0:0: Tagged Queuing enabled. Depth 5 scsi0:0:1:0: Tagged Queuing enabled. Depth 5 scsi0:0:2:0: Tagged Queuing enabled. Depth 5 Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 Attached scsi disk sdb at scsi0, channel 0, id 1, lun 0 Attached scsi disk sdc at scsi0, channel 0, id 2, lun 0 (scsi0:A:0): 8.064MB/s transfers (8.064MHz, offset 15) SCSI device sda: 2118144 512-byte hdwr sectors (1084 MB) sda: sda1 sda2 < sda5 > scsi0:A:1): 8.064MB/s transfers (8.064MHz, offset 15) SCSI device sdb: 2118144 512-byte hdwr sectors (1084 MB) sdb: sdb1 < sdb5 > (scsi0:A:2): 8.064MB/s transfers (8.064MHz, offset 15) SCSI device sdc: 4124736 512-byte hdwr sectors (2112 MB) sdc: sdc1 < sdc5 > -- Systemboot: Adaptec-2940 V1.1\SNI back: FAB 566507-00 REV F ; SNI BARCODE 39079572 ; barcode: BE0E52003 UR; Chip: S26361-D8030-V1 Adaptec GS=2 front: ASSY 566506-00 ; lg. Chip: AHA-2940 S5 593300 D 9520 ; Chip: Adaptec Inc 589202-00 D 81051E00 '1994