I'm trying to get a RAID 1 (mirroring) setup and when my regular bios starts up, my drives are detected, but when I get into my Raid setup, NO drives are detected. I setup the bios to ATA133-RAID, but still nothing. Has anyone else got this to work? Here's what I've got: IDE1 Maxtor Drive - Creative CD IDE2 Western Dig - Sony CD-RW IDE3 Western Dig - just got it. Any thoughts would be great! Tom - - - - - - - - - - - - - - - - - - Tom Nielsen Neuro Logic Systems, Inc. 805.389.5435 x18 www.neuro-logic.com
On Tue September 23 2003 7:04 pm, Tom Nielsen wrote:
I'm trying to get a RAID 1 (mirroring) setup and when my regular bios starts up, my drives are detected, but when I get into my Raid setup, NO drives are detected. I setup the bios to ATA133-RAID, but still nothing.
Has anyone else got this to work?
<snip>
Any thoughts would be great!
Tom
Tom: I had used the KT7A-Raid until it blew. It used the Highpoint controller. If this is so for your board, try the Highpoint website for drivers, setup info. www.highpoint-tech.com. Richard
Richard,
I'm trying to get a RAID 1 (mirroring) setup and when my regular bios starts up, my drives are detected, but when I get into my Raid setup, NO drives are detected. I setup the bios to ATA133-RAID, but still nothing.
Has anyone else got this to work?
I couldn't get RAID 1 to work on a KR7A-RAID and in the end switched to a Gigabyte GA-7VRXP.
Maybe someone else had more luck ? Damian
participants (3)
-
Damian O'Hara -
Richard -
Tom Nielsen