Hello, I am using wireless networking. In Yast, Wicked Service is selected. The wlan0 interface is set for DHCP and the DNS config is left at default values. I recently (some time after upgrade to 42.2) started getting delays every time a host is looked up. /etc/resolv.conf has these uncommented lines: == search suse home nameserver fe80::1%wlan0 nameserver 192.168.1.254 == So it seems like an ipv6 version is checked first and does not work. I don't need ipv6. I understand I can use yast to switch to manual DNS configuration, and just put 192.168.1.254 there (or 8.8.8.8 even). But this could lead to problems down the line if I later have to configure a different connection. Is there any way I can remove the ipv6 version while keeping auto-configuration working? -- Yours, Mikhail Ramendik Unless explicitly stated, all opinions in my mail are my own and do not reflect the views of any organization -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org