MindBender wrote:

Ok ... what work is I can ping my SuSE box and do telnet on it Maybe is a router that I want admeting the router will allow me to do telnet and ftp and web from my other computer... to any other compute on the net, that is ok with me....But so far when I try from the the other computer to telnet a compute on the net it said that the host is unknow...

Right, what you want is IP masquerading then. You'll probably have to do some reading for this one, the most relevent texts being the ipchains and ip-masquerading HOWTOs. These should explain everything you need to do. Of course, if you have any problems, just give us a shout... that's what we're here for ;-)

Ps: I did edit my conf.modules but I still have to setup my Ethernet card after boot time...

Was the card set up in YaST? You should check to see if things are set up correctly in rc.config also. Interesting parts of rc.config include: NETCONFIG="_0" IPADDR_0="192.168.0.1" NETDEV_0="eth0" IFCONFIG_0="192.168.0.1 broadcast 192.168.0.255 netmask 255.255.255.0 up" not necessarily with those values though. What do you mean by set up anyway? Do you mean setting up IP addresses, etc. (for which the above is relevant), or actually getting the module to load? Tell us what you have to type in to 'set it up' and we'll see if we tell you where it's meant to go... Hope that helps, Chris -- __ _ -o)/ / (_)__ __ ____ __ Chris Reeves /\\ /__/ / _ \/ // /\ \/ / ICQ# 22219005 _\_v __/_/_//_/\_,_/ /_/\_\ -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/