Thanks jokes For the reply, Sorry I could not work "Samba" even a hard task trying to find it, I find two programs Settings => Information => samba status (you to log on as "root" user) Utilities => Samba setup tool But going through the Suse 6.4 book page Page 403 made changes to /etc/rc.config but I think the break through was with Page 200 made changes to /etc/smb.conf changed workgroup = workgoup to ; workgroup = workgoup workgroup = Erics One mistake I made at first, So when I make changes now is to "rem" them out with a ';' then repeat the line without the ';' otherwise it is hard to see what you have changed if things go bad, or else restore the old file ----- Original Message ----- From: "Eric Richards" <e.richards@clear.net.nz> To: "SuSE Linux (English) General Discussion" <suse-linux-e@suse.com> Sent: Saturday, September 16, 2000 2:39 PM Subject: [SLE] network : Hi : I have networked a 486 to a pentium, : On both computers windows 95 and on the pentium is dual boot to linux : windows to windows network ok : : but can not see network on windows to linux, : : like if you click onto "network neighbourhood" from the desk top when I have : dual booted to windows and both computers are going I can see 3 object(s) : entire network, and the two computers : : I can "ping" OK between windows and linux : : : >From Eric : : : : -- : To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com : For additional commands send e-mail to suse-linux-e-help@suse.com : Also check the FAQ at http://www.suse.com/support/faq : : -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/support/faq