"Stathy G. Touloumis" wrote:

...

But I have a similar problem with Vmware. I have 1.1.2, downloaded and installed by hand rather than off the disk. This also seems to fail to load the module at boot time and later says I have to run vmware-reconfig.pl. When I do, it takes the vmware things down, then puts them back up again, and it all works. After a reboot it's broken again.

Have the same problem, haven't gotten around to solving it though ; ) Since I do not reboot often it isn't a big hassle. Check out the faq and support pages at vmware.

I had a terrible problem once getting vmware started. vmware-config.pl wouldn't run either, complaining about the kernel. The fix for me was: make mrproper (which *really* cleans out your kernel build environment You'll have to re-enter all your kernel choices again) make depend make bzImage (whatever your kernel) mv arch/i386/boot/..... /....... make modules make modules_install lilo sync reboot Then run vmware-config.pl again. John -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/

On Sun, 26 Dec 1999, you wrote:

Western Digital EIDE hard drive just crashed. Wondering if anyone knows a good data recovery company.

Thanks,

Might help to know where you are located as I use a local company I would guess that is the case with many admins. -- ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Darren R. Weber drw@linuxfan.com ICQ# 2849193 ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/