Hi, CenturyLink has forced me to get a fiber connect using their DSL because my 9+ yr old one is contantly crashing an has anywhere from 20-90% packect loss. So I am trying to get both to work at the same time. I have been forced to put the DSL Modem a C1000A into bridged mode. Could not get the yast2 dsl to work. So I configured pppoe to work. When I do a pppoe-start and then add the estra routes with the route command I finally get to the netstat -nr for the 168.103.176.54 right below. This allows 168.103.176.54 to go out to the internet anywhere. But incoming stops at 168.103.176.54, But 168.103.176.54 is able to ping and connect and do anything from any in the IP blocks below. Puclick IP's purchased from CenturyLink. 168.103.176.48 All 0's (reserved) 168.103.176.49 168.103.176.50 168.103.176.51 168.103.176.52 168.103.176.53 168.103.176.54 Gateway or should be. 168.103.176.55 All 1's (reserved) openSUSE 12.1 machine using IP address 168.103.176.54 netstat -nr Kernel IP routing table Destination Gateway Genmask Flags MSS Window irtt Iface 0.0.0.0 67.41.239.69 0.0.0.0 UG 0 0 0 ppp0 0.0.0.0 168.103.176.54 0.0.0.0 UG 0 0 0 eth1 0.0.0.0 67.41.239.69 0.0.0.0 UG 0 0 0 ppp0 67.41.239.69 0.0.0.0 255.255.255.255 UH 0 0 0 ppp0 127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo 168.103.176.48 168.103.176.54 255.255.255.248 UG 0 0 0 eth1 169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth0 192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1 198.60.105.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 openSUSE 12.1 machine using IP address 198.60.105.2 and 168.103.176.52 on same nic. Only has one nic in machine. Everything stops at the gateway. IP address 168.103.176.54 when default is set to this gateway. I am able to do anything on the gateway 168.103.176.54 all the others from this machine only ping and traceroute works. netstat -nr Kernel IP routing table Destination Gateway Genmask Flags MSS Window irtt Iface 0.0.0.0 168.103.176.54 0.0.0.0 UG 0 0 0 eth0 127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo 168.103.176.48 0.0.0.0 255.255.255.248 U 0 0 0 eth0 169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth0 198.60.105.0 198.60.105.2 255.255.255.0 UG 0 0 0 eth0 When I change the gateway to 198.60.105.2 Everything works except the CenturyLink IP's other than the .54. I am able to ping and traceroute to the CenturyLink Ip's but unable to bring up other services. The 198.60.105.2 has problems because of what CenturyLink has done to this DSL link. netstat -nr Kernel IP routing table Destination Gateway Genmask Flags MSS Window irtt Iface 168.103.176.48 168.103.176.54 255.255.255.248 UG 0 0 0 eth0 168.103.176.48 0.0.0.0 255.255.255.248 U 0 0 0 eth0 198.60.105.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 eth1 169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 eth0 127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo 0.0.0.0 198.60.105.2 0.0.0.0 UG 0 0 0 eth0 So, I now need to make changes to the routes on 168.103.176.54 to some how get outside to go beyond the gateway 168.103.176.54 and to allow internal to go out just like the gateway 168.103.175.54. And the internal using CenturyLink IP's to use all services. Thanks, in advance for any ideas. -- Boyd Gerber 801 849-0213 ZENEZ 1042 East Fort Union #135, Midvale Utah 84047 -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org