After giving up on the YAST tool for creating Xen VMs I managed to roll my own and get it booting without too much effort. The problem I have is how to configure the networking in the VM, I've tried specifying the MAC address and bridge details in the config file but I can't work out how to actually configure the virtual interface card in YAST. I see on the opensuse site that in bridging mode dom-N is currently not setup properly, how do I do this manually ? Any help would be appreciated. -- David Bottrill david@bottrill.org www.bottrill.org Registered Linux user number 330730 Internet Free World Dialup: 683864
On Saturday 24 September 2005 02:45, David Bottrill wrote:
After giving up on the YAST tool for creating Xen VMs I managed to roll my own and get it booting without too much effort. The problem I have is how to configure the networking in the VM, I've tried specifying the MAC address and bridge details in the config file but I can't work out how to actually configure the virtual interface card in YAST.
I see on the opensuse site that in bridging mode dom-N is currently not setup properly, how do I do this manually ?
Any help would be appreciated.
I should have said I am running RC1 on i386. -- David Bottrill david@bottrill.org www.bottrill.org Registered Linux user number 330730 Internet Free World Dialup: 683864
participants (1)
-
David Bottrill