Johannes Nohl wrote / napísal(a):

Dear list,

I installed VirtualBox. Therefor I set up a Network Bridge. Now I have:

eth0 = physic. card, connected to the router IP 0.0.0.0 vbox0 = interface used by Virtualbox br0 = Bridge DHCP

With Firewall turned off, networking is no problem. VBox Guest and br0 receive their IP via DHCP from router.

But when I turn firewall on the VBox guest has no connection anymore. If have the following zones:

eth0 = internal br0 = not set any = external

Who can help?

I don't try this (with firewall) but it seems that br0 should be assigned to same zone that eth0 (internal). Try it and you'll see. -- Best Regards, Michal Zugec Software developer --------------------------------------------------------------------- SuSE CR, s.r.o. e-mail: mzugec@suse.cz Lihovarska 1060/12 tel: +420 284 028 960 190 00 Praha 9 fax: +420 296 542 374 Czech Republic http://www.suse.cz/ -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org