<PRE> I have an E-Tech PCI 56k internal modem which I'm trying to configure. I used minicom to create a configuration file. I set the serial device to /dev/ttyS2 since my modem is on the third serial port. The speed is set to 115200bps (Baud/Par/Bits: 115200 8N1). I saved the setup as default and tried to test my modem. I didn't get an OK prompt in the terminal. Oh yes, I also set the modem to the correct port with YaST during the installation. What am I doing wrong? </PRE> -- BEGIN included message</EM></P> <BLOCKQUOTE> <UL> <LI>To</em>: "<A HREF="mailto:suse-linux-e@suse.com">suse-linux-e@suse.com</A>" <<A HREF="mailto:suse-linux-e@suse.com">suse-linux-e@suse.com</A>></LI> <LI>Subject</em>: PCI Modem configuration</LI> <LI>From</em>: Yatsen Ng <<A HREF="mailto:yatsen-ng@cistron.nl">yatsen-ng@cistron.nl</A>></LI> <LI>Date</em>: Fri, 26 Feb 1999 15:21:43 +0100</LI> </UL> <BR>I have an E-Tech PCI 56k internal modem which I'm trying to configure. I used minicom <BR>to create a configuration file. I set the serial device to <B><FONT FACE="Arial,Helvetica">/dev/ttyS2</FONT></B> since my modem is <BR>on the third serial port. The speed is set to 115200bps (Baud/Par/Bits: 115200 8N1). <BR>I saved the setup as default and tried to test my modem. I didn't get an <B><FONT FACE="Arial,Helvetica">OK</FONT></B> prompt in the <BR>terminal. Oh yes, I also set the modem to the correct port with YaST during the <BR>installation. What am I doing wrong? <BR> </BLOCKQUOTE> -- END included message</EM></P>