This sounds like a good candidate to be added here: http://en.opensuse.org/HCL:Printers#Epson It will be lost if this is the only place it's posed. On Sat, Apr 19, 2014 at 11:19 AM, Carl Hartung <opensuse@cehartung.com> wrote:

I purchased an Epson XP-310 multifunction printer / scanner yesterday and set it up as a network appliance (Wi-Fi.) Setting up the printer side was straightforward but the scanner side took a fair bit of sleuthing and some trial and error. First, this device has only two interfaces, USB and Wi-Fi. Follow the manufacturer's instructions for connecting it to your network. Follow the steps, below, once that's done:

DOWNLOAD packages (x86_64 64-bit versions shown) from:

<http://www.epson.com/cgi-bin/Store/support/supDetail.jsp?oid=227224&BV_UseBVCookie=yes&infoType=Downloads&platform=OSF_O_LINUX>

epson-inkjet-printer-escpr-1.4.0-1lsb3.2.x86_64.rpm iscan-2.29.3-1.usb0.1.ltdl7.x86_64.rpm iscan-data-1.27.0-1.noarch.rpm iscan-network-nt-1.1.1-1.x86_64.rpm

MOVE packages to a new / empty temporary directory and INSTALL:

# zypper in *.rpm

--> This command will automatically fulfill dependencies.

EDIT /etc/sane.d/epkowa.conf

--> Comment out 'usb' and 'scsi' detection (unless you also have a SCSI or USB scanner) by inserting a leading hash mark (#) as needed.

--> ADD line "net XXX.XXX.XXX.XXX" (without the quotes) in network scanner section. Obviously, replace "XXX.XXX.XXX.XXX" with the IP address you assigned to the printer in your router.

EDIT /etc/sane.d/net.conf

--> Enter the printer's IP address in it's own line at the bottom of the file. E.g. "192.168.1.10" (without the quotes)

EDIT /etc/sane.d/dll.conf

--> uncomment the top line "#net" (becomes just "net", without the quotes)

RUN YaST -> Scanner module

--> SELECT "Scanning via Network..." from the "Options" drop-down list

--> verify meta driver 'net' says "No scanner recognized by this driver"

--> CLICK "OK"

--> CLICK the "Add" button, select "Epson Workforce 310 Series..."

--> CLICK "OK"

--> CLICK "Continue" at the '64-bit' / 'problematic' warning

--> CLICK "OK"

Launch "Image Scan! for Linux" (installed above.) This was found on my system under 'Graphics > Scanning'. Put a document on the scanner bed and click the 'Preview' button to test.

Hope this helps someone down the road ...

regards,

Carl -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org

C. -- openSUSE 13.1 x86_64, KDE 4.12 -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org