Where does this actually get set? In yast for eth0 I put in my gateway address of 192.168.1.1 (which is my IPMASQ server) but when I look in rc.config at the IFCONFIG_0 parameter it points to 192.168.1.255. If this is the wrong place, where do I put the value so my machine will try and route through my IP MASQ machine? -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/
On Tue, 27 Apr 1999, jperser wrote: j> Where does this actually get set? In yast for eth0 I put in my gateway j> address of 192.168.1.1 (which is my IPMASQ server) but when I look in j> rc.config at the IFCONFIG_0 parameter it points to 192.168.1.255. j> If this is the wrong place, where do I put the value so my machine will j> try and route through my IP MASQ machine? j> Goto "Network base configuration" navigate to the eth0 device you wish to configure and press F6. The third line down is the gateway address field. The first one is your IP address, which along with netmask (the second field) are whats entered into the IFCONFIG_0 parameter. The gateway address itself is entered into the /etc/route.conf file toward the bottom. -- S.Toms - tomas@primenet.com - http://www.primenet.com/~tomas SuSE Linux v6.2+ - Kernel 2.2.11 The 80's -- when you can't tell hairstyles from chemotherapy. -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/
participants (2)
-
jperser@airmail.net
-
tomas@primenet.com