Adding Samba mount to bootup process
Into which bootup script can I add the commands 'rcsmb start' and 'rcnmb start' to get these two process up and running properly? I added the commands to boot.local but eth0 comes online after boot.local. Then I want to mount two samba shares from a networked windows system. I'm assumming that the mouts can come directly after 'rcsmb' and 'rcnmb' Everything is working if I start the processes after booting. Regards, Jay
You can use Yast2 (Runlevel editor), or you can run: # chkconfig nmb on # chkconfig smb on # You can check what runlevels it's going to run by: # chkconfig -l nmb smb nmb 0:off 1:off 2:off 3:on 4:off 5:on 6:off smb 0:off 1:off 2:off 3:on 4:off 5:on 6:off # Wasn't this same exact question asked ~2 days ago? On Tuesday 18 February 2003 15:07, henjay wrote:
Into which bootup script can I add the commands 'rcsmb start' and 'rcnmb start' to get these two process up and running properly?
I added the commands to boot.local but eth0 comes online after boot.local.
Then I want to mount two samba shares from a networked windows system.
I'm assumming that the mouts can come directly after 'rcsmb' and 'rcnmb'
Everything is working if I start the processes after booting.
participants (2)
-
henjay
-
Karol Pietrzak