I'm trying to sneak a little Linux into my better-halfs life. After the install [ as above ] I can't get the viewing area of the screen to go to full width. It leaves about an inch of black all the way around the viewing area. As near as I can tell from the Gateway spec sheet it set the video driver right. The screen doesn't have much information, other than its a 13.3 TFT, I have it set to 14 in the config file. I've dug through every configuration setting I can find but nothing in SuSE will change it. Windows XP on the other half of the drive does just fine so I'm not so sure its a bios or hardware thing. Any ideas???????????? Gateway specs: LCD display panel Panel size 13.3-inch Panel type Active matrix thin filament transfer (TFT) LCD color display Maximum panel resolution 13.3-inch - (XGA) 1024 x 768 Maximum colors displayed 18-bit; 262,000 colors Video Graphics controller SMI Lynx EM4 Video Graphics Accelerator (Silicon Motion Inc.) Video interface Accelerated graphics port (AGP) 1X Video memory 4 MB SGRAM External video Supports simultaneous LCD, external monitor. Supports VGA (640 x 480), SVGA (800 x 600) and XGA (1024 x 768) panel. Internal LCD resolutions and maximum color depth 1024 x 768, 800 x 600, and 640 x 480 with up to 16.7 million colors Zoomed video Zoomed video card may be used in lower PC card slot only Display info from computer: Vendor Silicon Motion Inc Model SM 710 LynxEM Driver siliconmotion (no3d support) Monitor is set up as generic Vesa SVGA. Nothing in the Gateway list looked like anything usable. -- (o:]>*HUGGLES*<[:o) Billie Walsh The three best words in the English Language: "I LOVE YOU" Pass them on! -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org