Well my first problem has been overcome thanks to lenz:) Now I can use the tnt/riva card in 32bit mode. Now lets move on to the next problem (icyw I just bought a gateway g6-400... you should see how fast yast is!)... Since my computer is brand spanking new I decided to get the newest kernel... Everything seemed to work ok with the new kernel I compiled untill I tried to run the Gimp... that was when X crashed. Before this the Gimp ran fine with no problems. After repeating the same thing over again (and even reinstalling it) I gave up. But then the same thing happend when I tried to use Xrun (a gtk clui). So then I tried to run any gtk program that I had... all of them crashed X. I then rebooted with the old kernel and everything seemed to run fine. Has anyone experienced anything like this? Should I compile all of my gtk stuff with the new kernel (instead of using rpm)? I'm using the newest version of X (3.3.3.x) in case your wondering. Regards, joe ___________________________________________________________ Get your own Web-Based E-mail Service at <A HREF="http://www.zzn.com"><A HREF="http://www.zzn.com</A">http://www.zzn.com</A</A>> - To get out of this list, please send email to majordomo@suse.com with this text in its body: unsubscribe suse-linux-e Check out the SuSE-FAQ at <A HREF="http://www.suse.com/Support/Doku/FAQ/"><A HREF="http://www.suse.com/Support/Doku/FAQ/</A">http://www.suse.com/Support/Doku/FAQ/</A</A>> and the archiv at <A HREF="http://www.suse.com/Mailinglists/suse-linux-e/index.html"><A HREF="http://www.suse.com/Mailinglists/suse-linux-e/index.html</A">http://www.suse.com/Mailinglists/suse-linux-e/index.html</A</A>>