You forgot to post to the list, so others could not comment. On 04/10/2019 20.23, Doug McGarrett wrote:

On 10/04/2019 01:04 PM, Carlos E.R. wrote:

...

On 04/10/2019 16.31, Peter McD wrote:

...

Am 04.10.19 um 14:10 schrieb Carlos E. R.:

...

On 04/10/2019 13.45, Peter McD wrote:

...

Am 04.10.19 um 02:52 schrieb Doug McGarrett:

...

Thank you, Carlos! I believe that this worked. Your very detailed instructions are just what I needed to add the Packman stuff.

It looks lke it only partly worked. I can now see a picture when I try and open "This Glider Uses Water-Reactive Fuel to Launch" from the Pop Mech site, but I just get a little circle going around and around in the middle of the picture. Maybe the picture is defective, but I suspect there's still something missing. The other test video that someone suggested in this thread is viewable.

Well, maybe you need to restart the session or maybe reboot. Try "zypper ps" to see what is pending (as root or sudo). It is also possible that you need something else. Enter yast software manager again, search (in the search box) for "GStreamer" (name only). There should be a lot of them. Well, now, one by one you check that they come from packman (there is a version tab on the right hand panel). Some do not have a version on packman, so don't change them. You'll see a list of package versions and from where; the top line says what's the installed version. If it is not packman and there is one from packman, just tick on the one that says "packman". There should be none to change, as you did the switch yesterday. Maybe there is some not installed package, though; if that's the case, use your judgment to install them. Those will not have a tick on the left (right hand panel, top half). Ignore the -debuginfo or -devel or -doc packages. Possibly ignore the -32bit too. Me, I just did that and found some new ones. -- Cheers / Saludos, Carlos E. R. (from 15.0 x86_64 at Telcontar)