Brandon Carl wrote:
Hurray!! It is working! Great! Finally! I think I might create a tutorial on how to do this in case others run into the same situation I was in. Sounds like a good idea, while it is fresh.
So, finally, is there a way I can make absolutely sure the raid array is up, running, and mirroring before I release this server back onto my company's network?
-Brandon mdadm --detail /dev/md10 and mdadm --detail /dev/md11. That will tell you the present state. I have now forgotten which version you were using, but if 10.2 you can have mdadm (which you should have enabled in
On 07/12/2007 06:49 AM, Brandon Carl wrote: the runlevel editor) email you about any status changes, like a disk that goes offline for any reason. You can also test to make sure Yast Partitioner sees it all ok. Final test is a reboot. If it passes all those, it is good to go.
-- Joe Morris Registered Linux user 231871 running openSUSE 10.2 x86_64
I am running 10.2, but how would I set it up to email me?
Yast, System, etc/sysconfig Editor, System, File Systems, Mdadm, MDADM_MAIL. Just put in your email address. -- Joe
Thanks, although I'm not sure if I have sendmail configured correctly. -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org