On 2023-02-25 13:08, Per Jessen wrote:
Carlos E. R. wrote:
On 2023-02-25 12:38, Per Jessen wrote:
Per Jessen wrote:
Brandnew 15.3 just now rebooting on backend#1.
Well, not quite. It looks like dracut in 15.3 is also suffering from bug#1206781. I didn't wait for the time-out, nor did I check the serial console, but there is no sysctl in the initrd. Fortunately it is easy to add with dracut. Rebuilding the initrd with xz compression also shaves off almost 4Mb.
Are you using lilo on it? :-D
Most amusing :-) No, its booting over PXE. I was surprised to see xz compression saving about 20%, but of course it's hardly critical.
It is critical for those of us that have an old and separate /boot partition with a size that was ample ten years ago :-D
Being able to configure configure dracut with /etc/dracut/conf.d/ is quite nice.
I never had that need.
A little bit weird - /etc/resolv.conf did not get "populated".
Maybe a symlink to somewhere in /run? It should then be populated by networkmanager when it starts.
There is no networkmanager here, but yes, it should have been populated, it's really weird. I stopped firewalld and rebooted, et voila!, I have a proper /etc/resolv.conf
I can't really imagine firewalld having any influence though.
True. Must be coincidence :-? -- Cheers / Saludos, Carlos E. R. (from 15.4 x86_64 at Telcontar)