Anders Norrbring wrote:
MegaRAID SCSI 320-1, BIOS: G119, F/W: 1L37.
With [Alt]-[F4] you should be able to see the error message up to that point. Have you tried to define an Array in the Controller Bios prior to installation?
Now I tried setting the HBA to emulate an I2O device, same problem.. I also looked closely to the driever loading reports, it says it cannot get adapter status..
Could be a compatibility problem with the mainboard. Though it is strange that you can define Arrays but can't see the controller during installation. Have you tried to integrate the Controller into an existing running installation, just in order to have all commands available to investigate the module loading? If you can't get it running with an installed system chances are you will not be able at all to get the hardware combination working. Sandy -- List replies only please! Please address PMs to: news-reply (@) japantest (.) homelinux (.) com