I got the all-in-wounder to work with the 'r128' module. I could get it to work with the 'xf86config' to set it up but all i got was the server loading with no desktop. I then tried 'sax2' which they say not use, it did something but didn't set up right. i then ran 'xf86config' again and it all worked. mind you it did take me 2 days to get this far.
XFree 4.0.2 is intalled; however, we have not been able to find the right parameters for the config file to make startx work.
Under "device", we have tried inserting both "r128" and "Radeon" but this has only produced similar error messages.
The relevant output messages from the last "startx" attempt are stated below:
(WW) Warning, couldn't open module Radeon (EE) Failed to load module "Radeon" (module does not exist, 0) (EE) No drivers available.
Fatal server error: no screens found
The relevant output messages from "startx" attempt using "r128" as the device driver are stated below:
(EE) No devices detected.
Fatal server error: no screens found
Please help if you can. I've been working on this for 2 weeks with no success. Thanks for your time.
Mike Flug michael.flug@snet.net
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/support/faq
*--------------------------------* | Chris Large clarge@macn.bc.ca | | http://gone for now | *--------------------------------*