On Fri, 2007-12-28 at 18:25 -0500, william oakes wrote:
Folks,
I have installed OpenSuse 10.3 (from a downloaded ISO and from the retail package) on two of my computers without a problem.
The third computer is giving me fits. It presently has v.10.2 loaded. When I boot from the DVD to install v.10.3 from the retail package, Yast comes up without any problems, but bombs out when it tries to load the repositories from the DVD. I have tried two separate DVD drives, the newest was a double layer drive. The double layer drive gives error message that no repositories were found. Running check media gives a message stating that the media is broke. The second DVD brings up Yast but fails to install the repositories and keeps asking to retry.
Is there some setting I can use to ensure that the repositories are found on the DVD. This is the same DVD that I used to install 10.3 on the other computers.
Any advice would be appreciated.
TIA
Regards, Bill...
Just taking a wild stab here at narrowing down potential causes. I'm assuming the hardware on this third box is completely different from the other two boxes you mentioned? If that's the case, and if its not too much trouble, see if there's any difference in behavior if you swapped the DVD drive from one of the other boxes into this third box. If it doesn't give out on you this time, then its a problem with the DVD drive. In which case, file a bug. :-) -- ---Bryen--- -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org