Hi Folks, I've finally started to move 42.3 systems to Leap 15 and have run into some issues with firewalld. The basic install works okay on this dual-stack v4/v6 network, but when I try to configure two interfaces (exterior/interior) I lose my v6 address assignment. Stopping the firewall allows dhcpv6 to work, starting the firewall breaks it again. I've explicitly tried to enable the dhcpv6 service, and to enable logging for troubleshooting, all to no avail. The GUI interface is confusing at best, and I've got direct experience with ipchains and iptables, so I didn't just fall off of the turnip truck. Does anyone have experience with Shorewall as a replacement for firewalld? I'm tempted to try it before I get too far into the weeds with firewalld. Any suggestions? Regards, Lew -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org