Hi everyone, I'm on the last leg of my (seemingly hopeless) quest to get a Linksys CardBus card to work in Linux. After receiving advice from you guys I almost skipped ordering it, but Linksys had a link to a driver project for the cards (and that site claimed that their driver did infact work). Sadly, I haven't been able to figure out one of the most critical parts - how to get it to work. Apparently the problem is that the pcmcia card manager recognizes the card but it is not properly assigned an IRQ and I/O address. This results in an error when it the service tries to install it at boot, or via modprobe. The tulip driver people suggested that the problem was in /etc/pcmcia/config.opt's setting for IRQ's, but I'm at a loss at what I need to do. Does anyone have any suggestions? Thanks, Tim -- ----------------------------------------------------------------- Timothy R. Butler Universal Networks ICQ #12495932 AIM: Uninettm Christian Web Services Since 1996 tbutler@uninetsolutions.com http://www.uninetsolutions.com ============== "Information Powered by Innovation" ============== "AT&T: The pre-paid phone card. Jesus: The pre-paid life card."