This is a dual core pentium 4 hp dc5000 looks like 2 gigs of ram I had trouble with one module tg3 but it installed when I go to set up the network card which it detects, it says it cannot configure because the kernel device, eth0, wlan0, firmware, is not present Harware information in yast says it is d530 CMT DG746A BCMS782 gigabit ethernet manufacturer is broadcom the spec d530 CMT DG746A also shows up0 at the IDE controller under storage media this was fine when I got the box with centos 6 on it the error message also said to consult dmesg dmesg is big :) what am I looking for? How do I get the card working? it will be a wired connection with a static ip This will be my first experience with kde 4 too are there good places to look for basic help other than the docs? -- Bob Rea mailto:gapetard@stsams.org http://www.petard.us http://www.petard.us/blog http://www.petard.us/gallery Where is Bill Stringfellow now that we really need him? -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org