I am so happy with 11.1 that I decided to install it on an older Dell Latitue X200 laptop. The install went smoothly until I got to the configure hardware section. I did not do my homework as well as I should have before starting the install or I would have known this laptop uses a display resolution of 1024x768. Instead at the original startup screen for the install I opted to use the 800x600 resolution that openSUSE had choosen. Needless to say but when I try to start X at 800x600 it blows up forcing a reboot. I am now at the point that I start up and go to init 3. From there I start sax2 but have so far been unable to get sax2 to use any resolution other that 800x600. I read the man pages for sax2 but didn't see a switch to force a specific screen resolution. I even deleted all of the xorg.conf files but sax2 still used 800x600 the next time I started it. How can I get sax2 to use 1024x768 to configure the xserver? Thanks, Dave -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org