I just installed and tried to run Realcrypt under OpenSuSE 12.3 x64 and ran into a hiccup. When I tried to mount an encrypted volume I got the following error - "Failed to set up a loop device" Searching around the internet I found what may be a partial solution and that was to execute the following command - modprobe loop and indeed that seems to have gotten Realcrypt working for me. Not that I have any idea what I am doing, I am NOT an expert on the Linux kernel by any means.. So my questions are these - Did this make a permanent change to my system and if so good or bad? My internet searching found references to making a change in a file called rc.conf but I cannot find this particular file. Where should I look for it? If this loop kernel module is required by Realcrypt, why didn't YaST load if for me when I selected Realcrypt for installation? Seems like I shouldn't have to go and hunt this solution down like this. Marc.. -- "The Truth is out there" - Spooky -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org