hi,
After the install process is complete, openSUSE WILL boot. However it only continue to do so only if /dev/sda exists. In order to correct it, do the following as root grub device (hd0) /dev/sda root (hd0,0) setup (hd0) device (hd0) /dev/sdb root (hd0,0) setup (hd0)
i am new to md and software-raid and have never used it before. i have a cleaninstall of opensuse 11.1 x86 and two sata disks sda and sdb, same size, same model. all attached to same sata controller. i have created sda1=2gig and sdb1=1gig for swap and rest of harddisk sda2 and rest of other disk too sdb2. all during install time. then created the raid1 stuff during the yast2 gui all during setup time while booting from the 11.1 install dvd. system booted up fine when using both disks. im trying raid1 (md0 = swap on sda1 and sdb1, md1=/ on sda2 and sdb2) with opensuse 11.1 how do i check these grub settings to verify if grub has been installed properly. do the above grub commands also apply to my setup, and when/where to i enter them? during runtime of my 11.1 system (runlevel3 runlevel5)? or do i need to boot from install dvd or runlevel1 or something? thanks for hints and explanations. -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org