On Friday 04 March 2005 10:11 am, Bruce Marshall wrote:
On Friday 04 March 2005 09:51 am, Marcus Meissner wrote:
Sorry.... but I get the same thing.
bmarsh@linux1:~> /sbin/resmgr list status code 200 server message follows: no devices available
You did not login via kdm or gdm, so resmgr did not see you login I suspect. How did you start your X session?
Ciao, Marcus
Ok, back to square one on this. I think what happened with my previous resmgr list results was that I had done a resmgr restart at some point, thus it hadn't seen me login after that. So I have done a reboot of the machine, and done the normal login. The resmgr list results look more normal. However, even with a fresh boot, going into digikam with the camera previously defined to it still does not allow the camera to connect. I can then go into the 'add camera' dialog, remove the S1, re-detect it, get out of the dialog, and I am good for that one session. The camera will connect. The camera is good only for the session where digikam is allowed to auto-detect it. Sounds like it might be a problem with digikam (or gphoto2) to me.