On 15/08/2019 16.21, James Knott wrote:
On 2019-08-14 05:54 PM, Carlos E. R. wrote:
Basically the instructions are:
+++................... * Server IPv4 Address: we must indicate the IP address that appears in Tunnelbroker as "Server IPv4 Address". * Client IPv6 Address: we must indicate the IP address that appears in Tunnelbroker as "Client IPv6 Address", but without the /64 at the end. * IPv6 Prefix Length: we must indicate the /64 that we have in the final part of the IP address. Simply indicate the "64" without the bar. * Server IPv6 Address: we must indicate the IP address that appears in Tunnelbroker as "Server IPv6 Address", but without the /64 at the end, only the IP address without the prefix. * Tunnel MTU: we select the default value of the tunnel which is 1480. * Tunnel TTL: select 255 which is the default value.
In the section of "IPv6 LAN Seetings" we must indicate:
* LAN Prefix Length: normally in the tunnels that we create is /64, therefore, we should simply indicate "64". In case you ask for a /48, you must use this prefix. * LAN IPv6 Prefix: we must indicate the address that appears in Tunnelbroker as "Routed /64", but without the /64 at the end, and ended with "::" as you can see.
(Translated with www.DeepL.com/Translator) ...................++-
I don't have any of that :-(
I've just been going through their tunnel configuration and I see the server and client IPv4 & IPv6 addresses, along with the prefixes.
Sure. But the entries in my router 6in4 configuration are different. Can't be applied. -- Cheers / Saludos, Carlos E. R. (from 15.0 x86_64 at Telcontar)