I am trying to set up a small network these days, and I have installed a D-Link DFE-530TX in the machine acting as server. The kernel I use on this machine is not one of the standard SuSE 6.2 kernels, since I need some stuff that is not in these kernels. With YaST I have gone through the manouevres to activate the card as eth0, and that should be in place. However, when I boot, I get the message "module eth0 is not found". My question is now: Is there any way I can extract this module from somewhere, and put it in the correct place manually? That would be very helpful. Best regards, David List -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/