Lukacs Zsolt wrote:
Hello
Start Yast2. Then go to System->Runlevel editor. Select the hwscan module then in the "Start/Stop/Refresh" combo box select Stop. After that uncheck all the checkboxes where it says: "Service will be started in the following runlevels:" then Finish and I think that's it.
Zsolt
Basil Chupin wrote:
Would someone please remind me which control file, and where it resides, that needs to be massaged to stop the hardware scan on boot. (Which parameter to alter would also be helpful.) The RunLevel editor in the Control Centre refuses to switch off this check.
Thanks in advance
All been done at least 7 times with the same results: RunLevel editor shows hwscan as Running. -- Understanding only begins with the act of perception.