Hi List , I work in an environment where 5 of us have installed SUSE-10.0 ,All of us have an intel i845 chipset , and one of these three LCD monitors, Dell E151Fpb , Acer AL-1512 ,HP -1502 At install time yast2 is able to probe the graphics card and the monitor properly and run the display at 1024x768 and 16.7 million colours.However when we play games like torcs/bz-flags which make use of 3D Accln /direct rendering etc...and quit , the display on the screen starts scrolling infinitely and resizes itself based on mouse movement ,even switching to init 3 and coming back to 5 does not help.The only option is reboot, where i think the bios resets something and it starts working again. besides sometimes when we check a box in yast2->h/w->desktop and monitor to activate 3-D and click test the display blanks ,and so do Ctrl+Alt+F1-7 VTs Also once in a while , the display goes off ,even the CTrl+Alt-F[1-6] screens go off..with the following output on the LCD :"Input not support." Again when such blanking happens , the only option left is to reboot.running sax2 after any of the above scenarios results in a suboptimal display like (800x600 & 65536 colours) ,it gives the option to change the configuration ,and on selecting 1024x768 ,16.7M ,the console blanks. What we do now , is forcibly restore xorg.conf like mv /etc/X11/xorg.conf.saxsave /etc/X11/xorg.conf and say startx or init 5 but the whole cycle repeats again and again...when we play games or when we try to reconfigure X like adding a mouse ,or trying a new monitor etc.....we are so frustrated that we are planning to go back to Suse-9.2 which never had such issues. Any Pointers Digz