On Thursday 26 May 2005 22:50, Steven T. Hatton wrote:
Has anyone else had a problem with X getting confused between the /etc/X11/xorg.conf and /etc/X11/XF86Config? I just installed a new NVidia GeForce 6800 GT. The setup was an adventure to say the least. I kept having problems where X would start with one configuration on boot, and another when it was restarted. I finally deleted the /etc/X11/xorg.conf and changed the /etc/X11/XF86Config by hand, to put the correct modeline at the top of the list, and give it the correct DisplaySize values.
Anyone else had these problems? -- Steven,
Yes and no. This started to happen when I changed my monitor. On bootup some times I get a screen fom the bios that says I did not pass a parameter. The booting screen then boots using much larger fonts than normally. Once booted it appears ??? to be normal. Not sure but I seem to be getting minor different graphical changes. I do know that the xorg.conf file has not been touched with the monitor change.(Still shows the old monitor and dated before the change) The XF86Conf. file shows the new settings. The nvidia card settings are also different (0X0342 vs. GEForce 5700) I have been told that Yast is supposed to write to the xorg file with a link to XF86Conf. This apparently is not happening. No idea which config is being called; must be XF86. So maybe the problem is the same?? Don't know. Seems likely, and don't know what to do about it. Bob S. BTW 9.2 and KDE 3.4