Hello, I have some problem to manage usb3. I use a pci-express card with 4 usb3 connectors. for some weeks, no problems. I had an usb3 hard drive connected. This disk was seen at boot (or at connect) and notified by the applet. now it is no more notifyed (since approx a week) config, update or other problem? During this period I tested some USB 3 hubs (4 ports) with overall bad results. Two hubs from two different vendors may be during the tests something did corrupt the previous install? the problepm with the hubs was an unreliable connection. The drives are seen or not, depending of... I don't know. the two hubs have a 5V power. so... is this install not normal? is the card seen as a hub and the system do not like two cascading hubs? here dmesg: I remove the HDD: [ 2428.271735] usb 2-1.1: USB disconnect, device number 3 I insert it again in an other port: [39408.168703] usb 4-3: new SuperSpeed USB device number 5 using xhci_hcd [39408.179813] usb 4-3: Parent hub missing LPM exit latency info. Power management will be impacted. [39408.180640] usb 4-3: New USB device found, idVendor=0bc2, idProduct=5031 [39408.180646] usb 4-3: New USB device strings: Mfr=2, Product=3, SerialNumber=1 [39408.180650] usb 4-3: Product: FreeAgent GoFlex [39408.180654] usb 4-3: Manufacturer: Seagate [39408.180657] usb 4-3: SerialNumber: NA0Q8ZXF [39408.181485] scsi11 : usb-storage 4-3:1.0 [39409.187567] scsi 11:0:0:0: Direct-Access Seagate FreeAgent GoFlex 0219 PQ: 0 ANSI: 5 [39409.187926] sd 11:0:0:0: Attached scsi generic sg4 type 0 [39409.188347] sd 11:0:0:0: [sdd] 1953525167 512-byte logical blocks: (1.00 TB/931 GiB) [39409.189115] sd 11:0:0:0: [sdd] Write Protect is off [39409.189120] sd 11:0:0:0: [sdd] Mode Sense: 4f 00 00 00 [39409.190687] sd 11:0:0:0: [sdd] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA [39409.226559] sdd: sdd1 [39409.228490] sd 11:0:0:0: [sdd] Attached SCSI disk I can mount it, but of course as root /dev/sdd1 on /mnt type fuseblk (rw,nosuid,nodev,relatime,user_id=0,group_id=0,allow_other,blksize=4096) the same disk reacts perfectly when connected on usb2 any idea? thanks jdd -- http://www.dodin.org -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org