I upgraded from 6.2 to 6.3 last night. It all went mostly OK, but I was left with two problems, related I think. My network card wasn't recognised when booting. The module wasn't being loaded. If I loaded it manually and restarted the network it was happy. I found the line in modules.conf was reading "alias eth0 off". I changed it to "alias eth0 tulip" and all was happy again. But I have a similar problem with Vmware. I have 1.1.2, downloaded and installed by hand rather than off the disk. This also seems to fail to load the module at boot time and later says I have to run vmware-reconfig.pl. When I do, it takes the vmware things down, then puts them back up again, and it all works. After a reboot it's broken again. What do I need to to tweak to have the Vmware module loaded correctly at boot time? -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/