![](https://seccdn.libravatar.org/avatar/77cb4da5f72bc176182dcc33f03a18f3.jpg?s=120&d=mm&r=g)
-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 The Tuesday 2007-05-08 at 15:17 +0200, Wilfred van Velzen wrote:
Probably busy enough that the test doesn't progress (much). If the test is well designed, the normal disk activity has priority.
It seems that way.
Probably you just have to wait longer and see.
I'm in no hurry, I'll wait until tomorrow, by which time the remaining 30% should be finished.
Ok! Now we'll sit waiting for your email a week from now: It's going at 99% still! I'm joking :-P My 300 GiB from Seagate, a test like that makes postfix growl with all kinds of timeout errors. I have to stop services (no raid). You are lucky with yours ;-)
There is a trick, although you may not like it. f the raid is in software, you can deactivate one of the hard disks (simulate a failure). The other disk(s) take over the load, the failed one goes idle, and the test can happily progress on that one. However, if the other disk goes down in the interval... ouch :-(
It's software raid, and I thought of this, but don't like it... ;)
No, you are right. It's not good for one's heart or stomach ulcers. Actually, it's good for the ulcers. :-p
ATA Error Count: 251 (device log contains only the most recent five errors) ...
There are no errors in the log:
# smartctl -l error /dev/sdb
Curious...
Also, you know that you can have an "active spare" inside the raid. If there is a problem, it will immediately activate it and switch over. The disadvantage is, obviously, that the spare is powered up, although idle. In those cases, I would have an spare outside, too - maybe I'm too paranoid ;-)
There isn't room inside the server (it's a 1U 19" with only two HD drive bays), so I don't have to consider this. ;)
Ah, lucky again, no worries! - -- Cheers, Carlos E. R. -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.5 (GNU/Linux) Comment: Made with pgp4pine 1.76 iD8DBQFGQIuttTMYHG2NR9URAhgTAJ0exKQMp9uRSiOuCb4Y2aOtuiLvHgCfco+w raR3r4Y2OiS9rTVmQ4aPGRg= =AAOp -----END PGP SIGNATURE----- -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org