Hi, Thanks but i just want my connection started every boot time.The command is this: dhpcpd wlan0 Where to put it ? Also, if i try to configure my card with Yast, system screws up and never connect ot the net again, thanks again to Cisco systems. On 11/1/05, Guðlaugur Jóhannesson <gudlaugu@raunvis.hi.is> wrote:
Ilker wrote:
After every boot, i have to type "dhcpcd wlan0" as root.I just hate to do that every boot.Is there any solution ?
I do not know if what I am proposing will help that situation, I will only explain what I did on my laptop to get a wlan card with ndiswrapper working.
The first thing to do is go to YaST and network devices and select network cards. There you select yout network card from the list (or create a new one if it is not detected) and click on edit. In the advanced button you can select hardware details. There you should change the module to ndiswrapper. Also in the advanced button is detailed settings where you should select start at boot time. Once that is finished you push next and you should see some selection where you can edit the ESSID and encryption key. If that is not the case, you have to remove the configuration for the device and start again from fresh. At the first page in the configuration you can select the type. Change it to wireless and follow the above steps.
-- Guðlaugur Jóhannesson http://www.hi.is/~gudlaugu Phone: +354 849 8405
--------------------------------------------------------------------- To unsubscribe, e-mail: opensuse-unsubscribe@opensuse.org For additional commands, e-mail: opensuse-help@opensuse.org