Hi all I've just downloaded the brand new 2.4 pre8 kernel. I configured this like I did the same way I dit with the 2.2.14 kernel. The only new thing I did whas to enable the processor Winchip C6, which I thought I had installed. But When I try to boot the kernel with loadlin: c:\loadlin\loadlin c:\loadlin\bzImage4 root=/dev/hdb11 mem=73278 it doesn't get loaded. Sometimes it hangs in the decompression phase ( the little points on the screen in te 3th row) One time this succeeded, bus the next warnig was bad gzip or magic number. I know loadlin has a sort of debug mode, the -d, or -t flag. I used the -d flag, ant this doesn't give a faulty kernel message o.i.d. What is the right command to compile the kernel? I use make dep clean modules modules_install bzImage followed with the command depmod -a Can anybody give me a cleu? Thanks in advance -- "I am, in point of fact, a particularly haughty and exclusive person, of pre-Adamite ancestral descent. You will understand this when I tell you that I can trace my ancestry back to a protoplasmal primordial atomic globule. Consequently, my family pride is something inconceivable. I can't help it. I was born sneering." -- Pooh-Bah, "The Mikado", Gilbert & Sullivan ------------------------------------- This Email is 100% Virus Free! How do I know? ~ Because no Microsoft products were used to generate it! ------------------------------------- 11:00am up 11 min, 3 users, load average: 1.95, 1.26, 0.70 SuSE6.2 kernel 2.2.10 KDE1.1.2. -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/support/faq