A mié, 14 jun 2000, Mark B Withers va escriure: Hi Mark, this is my configuration for my two ne nics. /etc/conf.modules ------------- alias etho ne alias etho ne options ne io=0x300,0x320 irq=5,10 (you should change ne (novell eagle) for 3c509) Lilo only try to detect one nic card, for this reason, you must put this line in /etc/lilo.conf: append= "ether=0,0,eth1" Hope it helps. Bye ---------------- Simeó Reig simeo@tinet.org Barcelona (SPAIN) -----------------
Hello everybody!
I'm trying to set-up multiple network cards to work under S.u.S.E. 6.1.
I had to re-compile my kernel in order to use my machine as a gateway/firewall and wish to enable bridging between the two nic's. They are both 3 Com 509's, but for some reason the kernel will only recognise one under the new "experimental (to me)" kernel 2.2.16.
My original kernel (2.2.5) will recognise both nics and seems to use modules for the driver. On the newer kernel I loaded the nic driver as a builtin and therefore there is no module.
Should I recompile the kernel and use modules for the nic cards instead?
Thanks for listening!
Mark
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/