B. Stia wrote:
On Thursday 01 September 2005 08:34 am, Sid Boyce wrote:
B. Stia wrote:
Hello SuSE people.
Asked this question a little over a month ago and got no response. I just need to know the answer to this.
Running 9.2 with all updates. Please confirm or reject my assumptions.
9.2 uses xorg. correct? Anything written about X should be written to xorg.conf correct?
Here is my point. When I installed 9.2 all of the parameters of my monitor were written to xorg.conf. I changed out the monitor to a new tft/lcd monitor. Sax wrote the parameters of the new monitor to XF86Config. (The old monitor is still present in xorg.conf)
Now, everything seems to be working correctly but has left me somewhat confused and bewildered. Is my system using xorg, like it should be in 9.2 or has it changed up and is now using XF86Config. Or, is it using some combination of the two. Why did Yast do this?
I'll probably buy 10.0 when it is released so it is probably a moot point. Still would like to understand this though.
Bob S.
I've seen previously, not in 9.3, though I may have changed it, xorg.conf as a symlink to XF86Config. You can do "ls -l /etc/X11" to see what's there.
OK, did that and it shows the xorg.conf file (but not the XFree86.config file) There is no soft link there unless it is a system generated hard link which I cannot see.
/var/log/Xorg.0.log will give you a blow by blow account of what X uses. # grep xorg.conf /var/log/Xorg.0.log
OK did that and I got the same response as below.
(==) Using config file: "/etc/X11/xorg.conf"
Sooo, that means it is using the xorg file but why doesn't the new monitor show in the file and the old one is still present in that file. I do see some references to the new monitor under the nvidia settings though in Xorg.0 log.
Oh well !!!! ????
Bob S.
I would have expected sax2 to have changed the config file, but if it works, the mode lines must be OK. Apart from what is in the xorg.conf, X probes for stuff and the lines have the markers to distinguish where it got the information on every line, from /var/log/Xorg.0.log Markers: (--) probed, (**) from config file, (==) default setting, (++) from command line, (!!) notice, (II) informational, (WW) warning, (EE) error, (NI) not implemented, (??) unknown. Regards Sid. -- Sid Boyce ... Hamradio License G3VBV, Keen licensed Private Pilot Retired IBM/Amdahl Mainframes and Sun/Fujitsu Servers Tech Support Specialist Microsoft Windows Free Zone - Linux used for all Computing Tasks