On 06/01/2018 08:59 PM, Per Jessen wrote:
Leap 15 networking woes continue with another PC - Jetway JBC390F541WAA-19B with 10 network interfaces (all Intel i211 Rev03). It is critical infrastructure PC which is used as KVM host for routing software - VyOS (luckily I have a backup router).
Need to say, previously installed 42.3 worked without ANY problem whatsoever (unfortunately, SSD with old system is already reformatted). 100% fresh install (as Server in Yast installer + GUI) on new WD SSD (old SSD was OK but replaced for insurance), AppArmor, IPv6 and even firewall are disabled. Kernel scheduler set to deadline. All latest updates installed. Only ONE internal i211 ethernet interface currently used, static IP.
Networking doesn’t work at all, rcnetwork status shows “wicked [788]: eth9 setup-in-progress”, and this continues for forever. eth0 - eth8 are completely disconnected, no cables inside sockets This is clearly a problem with wicked and “igb" kernel module combo, because USB AX88772 Ethernet adapter works with the same PC with same cable and switch. Even LEDs on these interfaces are off all the time. When they have no cables attached, LEDs would be off. Do you have LEDs
Andrei Verovski wrote: lit on eth9 ?
Andrei, when posting logs and such, instead of everyone here getting 4000 lines, it might be better if you were to use paste.opensuse.org and just post the links.
In the logs I noticed:
wickedd-nanny[795]: eth9: state=device-up want=network-up, wait-for=link-up
This seems to indicate tat eth9 does not have a connection. Can you perhaps post output from "ip addr show dev eth9" and "ethtool eth9" ?
Cables are attached that's the problem! LEDs are on until Leap tries load kernel modules and/or configure networking. I already filed a bug. https://bugzilla.suse.com/show_bug.cgi?id=1095598 I'll post more info on Monday, PC is in the office. -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org