Greets; Have a USB Key adapter that I have been working on for my laptop. Everything is done except the network integration.Card is recognized, drivers load and wavemon shows traffic. Network integration is missing however. Here is where I get stuck. The two references that I have relied on are helpfull but fail to describe the last missing nuggest. http://at76c503a.berlios.de/distro_suse.html and http://lists.suse.com/archive/suse-linux-e/2004-Sep/0070.html I get the same errors, iwconfig wlan0 IEEE 802.11-DS ESSID:"linksys" Nickname:"okuwlan" Mode:Managed Channel:6 Access Point: 00:0F:66:05:41:83 Bit Rate:11Mb/s Tx-Power=15 dBm Retry limit:8 RTS thr=1536 B Fragment thr=1536 B Encryption key:off Power Management:off Link Quality:0/0 Signal level:117/255 Noise level:0/0 Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 t23:/home/chris123 # ifup wlan0 wlan0 ERROR: No configuration found for wlan0 Now /etc/sysconfig/hardware/ contains config hwcfg-bus-pci-0000:02:08.0 hwcfg-static-0 scripts skel and hwcfg-bus-pci-0000:02:08.0 reads MODULE='e100' MODULE_OPTIONS='' STARTMODE='auto' which is correct for my nic on my laptop but not for the USB Key Adapter. As I want both the nic and adapter to be activated at different times not sure what I should enter into this file. SuSE detects everything fine (and yes as reported you cannot configure this with yast). Hardware detection reads as follows: Amtel unclassified device Bus: usb Device identifier: 226835 Driver: at76c505-rfm2958 Model: Atmel Unclassified device Old Unique key: 9yrU.qNRvD2d8381 lots more stuff then bus_hwcfg: usb sysfs_bus_id: 2-1:1.0 Any suggestion to complete this last step would be greatly appreciated. Regards and tks in advance. /ch