8 May
2009
8 May
'09
11:00
Per Inge Oestmoen wrote:
Per Jessen wrote:
I was about to say the very same thing, but it's not correct. If you run 'yast', you get the ncurses interface, if you run YaST2 you get the GUI (assuming DISPLAY is set). I've just tried it on an 11.1 system.
In this case, there was a major practical difference: Whereas the YaST2 function could never detect my drive, yast did.
Well, that's not possible coz' yast and yast2 really is the same code (look it up, yast is just a symlink). It's more likely that something changed in between you calling yast and then YaST2. /Per -- Per Jessen, Zürich (22.6°C) -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org