Re: [opensuse] Re: Bonding two network cards

17 May 2007

      eshsf wrote:
...
Hello,
On Thu, 17 May 2007 13:25:03 +0200
Jan Kalcic  wrote:
...
Michael Kershaw wrote:
...
Jan,
In your ifcfg-bond0, instead of listing the interface as the
bonding_slave's, have you tried to tell it the pci info instead like
so:
BONDING_SLAVE0='bus-pci-0000:04:02.0'
BONDING_SLAVE1='bus-pci-0000:04:02.1'
Here's my complete ifcfg-bond0:
BOOTPROTO='static'
BROADCAST='192.168.148.31'
IPADDR='192.168.148.30'
MTU='1500'
NETMASK='255.255.255.224'
NETWORK='192.168.148.0'
REMOTE_IPADDR=''
STARTMODE='onboot'
BONDING_MASTER='yes'
BONDING_MODULE_OPTS='mode=active-backup miimon=100'
BONDING_SLAVE0='bus-pci-0000:04:02.0'
BONDING_SLAVE1='bus-pci-0000:04:02.1'
Let me know if this helps!
Unfortunately not. I still have the problem both using pci info and
adapting your config file. I guess is something wrong with the
configuration as I have the same problem anywhere I try (openSuSE as
well as SLES)
I'm not using bonding. so, I'm not sure, but is this related to the issue?
https://bugzilla.novell.com/show_bug.cgi?id=250620
Regards,
eshsf
Hi eshsf,

the bug you mentioned is not regarding the problem I have. When I ifdown
any enslaved interface the bond0 interface goes down properly. Instead,
when I simulate a link failure doing 'ifconfig eth0 down' or
disconnecting  the device from vmware console the problem described occurs.

Jan
-- 
To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org
For additional commands, e-mail: opensuse+help@opensuse.org