Hi Jeffrey, thanks for the answer.
On next reboot, it takes quite long (>60s) to go over the Grub showing the boot menu and the system is not booting into runlevel 5 at all, last message seen is "Started SuSEfirewall2 phase 2". ... I can get over the "Started SuSEfirewall2 phase 2" if I switch the network from NetworkManager to ipup, but then I'm not able to get a Wifi connection anymore (only SSIDs viewable, but no IP-connection). ... This may have changed but IIRC, installation over WiFi is/was not recommended. In the past, I did it anyway and ended up with an unusable installation. So I started over with a wired connection. That worked. Well, while this sounds "stupid" (because there are users who only have wifi), the first installation was done directly with a wired connection because the Atheros wifi was not recognized.
Anyway I had the same problem, with the non-starting system, decribed above. So I changed from the NetworkManager to "ifup" too and replaced the Atheros with an Intel. Then the system started into runlevel 5, I got the wifi recognized, could select a wifi ap but never got any connection to my network. Finally I reinstalled everything again, this time wifi was available during installation, but again could not connect to my network, so I selected the wired network to finish the installation. But even with this second try it hangs during startup ... What can I check, because this just is a "show stopper" for me :-( -- kind regards, Thorolf -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse+owner@opensuse.org