Hello, In the Message; Subject : [opensuse] 10.2 and SaX2 problem Message-ID : <200702222320.21683.suselinux@cehartung.com> Date & Time: Thu, 22 Feb 2007 23:20:20 -0500 [Carl] == Carl Hartung <suselinux@cehartung.com> has written: Carl> Hi All, Carl> Up through SUSE 9.3, SaX2 accepted the following configuration for my on-board Carl> graphics chip, SiS 630, and monitor, an NEC MultiSync 77F: Carl> Monitor Carl> display size: 325 x 244 mm, aspect ration 4:3 Carl> horizontal rate: 28 to 70 Khz Carl> vertical rate: 54 to 120 Hz Carl> colors: 8-bit, 16-bit (24-bit to 1280 x 1024; 32 bit to 1152 x 900) Carl> --> 1600 x 1200 at 16-bit color was my preferred and default setting [...] Carl> seems to just ignore/reject them and they're overwritten to 1280 x 1024 at Carl> 24-bit. Because, Carl> horizontal rate: 28 to 70 Khz is too low for 1600x1200x24 bit. Set this; horizsync 28 - 76 KHz For this, the refresh rate becomes 60Hz. In case of CRT display, the higher, the better. So, set the maximum value of horizontal sysnc according with the display's manual. Regards. --- Masaru Nomiya mail-to: nomiya @ galaxy.dti.ne.jp "Bill! You married with Computers. Not with Me!" "No..., with money." -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org