From /var/log/messages as I plug in the device: Code:
kernel: usb 3-2: new full speed USB device using ohci_hcd and address 2 kernel: usb 3-2: configuration #1 chosen from 1 choice kernel: usb 3-2: New USB device found, idVendor=057c, idProduct=3a00 kernel: usb 3-2: New USB device strings: Mfr=1, Product=2, kernel: usb 3-2: Product: USB DSL Device kernel: usb 3-2: Manufacturer: AVM kernel: eth1: register 'cdc_ether' at usb-0000:00:13.2-2, CDC Ethernet Device, 00:04:0e:20:13:12 kernel: usbcore: registered new interface driver cdc_ether ifup: eth1 ifup: No configuration found for eth1 This is OK, since it isn't configured yet. I start YaST->Network Devices->Network Settings and see: USB DSL Device: Not configured RTL8111/8168B PCI Express Gigabit Ethernet controller: DHCP I select the DSL Device and click edit. This takes me to the address tab where I see: Device Type: ARCnet (Is this right? But it can't be changed.) And Dynamic Address DHCP I click 'Next' and 'Finish' and YaST seemingly completes with no errors. However, 'network restart' results in this appearing in /var/log/messages: ifup: eth1 syslog-ng[1929]: new configuration initialized ifup: No configuration found for eth1 Going back to YaST->Network Devices->Network Settings the DSL Device is listed as Not configured. Can someone help me fix or troubleshoot further? Thanks -- To unsubscribe, e-mail: opensuse+unsubscribe@opensuse.org For additional commands, e-mail: opensuse+help@opensuse.org