Hi all, I'm unable to install SuSE 7.3 that I've downloaded from FTP SuSE Server on my COMPAQ Proliant 800. It has a scsi port(53c875) connected to two scsi harddisks(Seagate 4GB x 2). I'm unable to use the scsi harddisks because they could not mount their partitions(sdax and sdbx). I tried to load modules from "Load SCSI modules" menu in yast1 such as sym53c8xx, ncr53c8xx and 53c7,8xx. Yast1 showed a message like "Module 'sym53c8xx' loaded successfully!"(no parameter for sym53c8xx) for sym53c8xx module but another modules, yast1 showed a message like "Failed to load module". After loaded sym53c8xx module, there was a kernel messages like this : sym53c8xx : at pci bus 1, device 4, function 0 sym53c8xx : 53c875 detected sym53c875-0 : rev 0x3 on pci bus 1 device 4 function 0 irq 10 sym53c875-0 : ID 7, Fast-20, Parity Checking scsi0 : sym53c8xx-1.7.3c-20010512 sym53c875-0-<0,*> : FAST 20 WIDE SCSI 40.0 MB/S (50.0 ns, offset 15) sym53c875-0 : SCSI parity error detected : SCR1=1 DBC=11000070 SBCL=ae sym53c875-0 : SCSI parity error detected : SCR1=1 DBC=1100002e SBCL=ae sym53c875-0 : SCSI parity error detected : SCR1=1 DBC=1100002e SBCL=ae sym53c875-0 : SCSI parity error detected : SCR1=1 DBC=1100002e SBCL=ae scsi0 : channel 0 target 0 lun 0 request sense failed, performing reset. SCSI bus is being reset for host 0 channel 0 sym53c8xx_reset : pid=0 reset_flag=1 serisl_number=0 serial_number_at_timeout=0 scsi0 : device driver called scsi_done() for a synchronous reset sym53c875-0-<0,*> : FAST 20 WIDE SCSI 40.0 MB/S (50.0 ns, offset 15) .................................................................... .................................................................... ................................................................... When I tried to start installation from harddisk, yast1 could not mount the harddisk partition. I think somthing needs to be configured somewhere. Any ideas? Thanks in advance, mtagoon