Nicholas wrote:
$ modprobe aic7xxx
except if you want to boot from a scsi hd you will need to recompile the kernel with scsi supported on kernel.
other choice would be the use of the initial ramdisk; this should contain the module in this case. See the SuSE manual about "particularities of SuSE Linux)
N
ps. I think tape drivers are access trough /dev/st* - not sure
/dev/st0 is the rewinding tape unit. After loading the SCSI module, you can misuse cdrecord (cdrecord -scanbus) to check wether the streamer has been found. Juergen
Nico Morrison wrote:
Adaptec 2930 & HP SureStore, trying to get to work with BRU.
System does not seem to see the SCSI drive at all & tape will not mount.
Any suggestions or resources welcomed.
-- =========================================== __ _ Juergen Braukmann juergen.braukmann@gmx.de| -o)/ / (_)__ __ ____ __ Tel: 0201-743648 dk4jb@db0qs.#nrw.deu.eu | /\\ /__/ / _ \/ // /\ \/ / ===========================================_\_v __/_/_//_/\_,_/ /_/\_\ -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/